

Wall bracket for log-wl500gsm
Wall bracket for log-wl500gsm
1-wire Combi Sensor
Temperature: -20 - +60 ° C +/- 0.6 ° C
Resolution: 0.1 ° C
Humidity (Moisture): 5 -95% Rh +/- 5%
Resolution 0.1%Rh
IP54 Plastic housing, very sturdy
Up to 8 sensors on the same 1-wire
16 bits at temperature
12 bits at moisture
Supply Voltage: 4.5 / 25mW
Dimensions: 74 x 66 x 36 mm
TSH230 is an IP54 temperature and humidity sensor with 1-wire interface. The temperature and moisture sensor integrated the basic elements plus signal treatment and provides a fully calibrated digital output. A unique capacitive element is used to measure relative humidity while the temperature is measured by a band GAP element. Both elements are seamlessly coupled to a 12-bit analog to digital converter. This results in superior signal quality.
The digital sensor is mounted in an IP54 classified cabinet with a sintered filter. This provides protection against dust and water jets. A cable gland with lock nut and screwless terminal block provides easy cable installation
Wall bracket for log-wl500gsm
The motion sensor light detection, temperature sensor for energy management
Connects energy management, local-lighting control via RS485 port
With powerful built-in relay for simple light activation 250VAC (1500 Watt T8 )
360 ° motion detection - up to 8 m in diameter and 4 meters height
Time delay / Sensitivity is adjustable
temperature sensor, - measuring the room temperature or fire alarm
Relay output to turn on the light via the PIR / light-strength and temperature sensors
RS485 2-wire communication bus
DCON and Modbus RTU protocols
ceiling surface mounted design
Supply voltage: 10 - 30VDC ca. 2W
Dimensions: Ø121 x 52 mm | IP20
Advanced Controller with logging
With slot for internal I/O expansion module, A/D, D/A, D/I, D/O, relay
Program with simple logic functions - WISE (Web Inside Smart Engine)
Logic functions with IF-THEN-ELSE logic
Supports SNMP, SMTP, FTP, MQTT, Modbus / TCP / RTU and DCON
Ethernet 10/100 / 1000Mbit
Setup via the built-in Web server
1 x RS232 port
2 x RS485 port
Supply voltage: 12 - 48VDC
Dataopsamler med display og USB
Kun til T&D BLÅ SERIE Dataloggere