A load cell is a transducer which generates an electrical signal whose size is directly proportional to the force transducer is affected by.
a load cell may take many forms in steel, aluminum, where the choice of material allows the load cell the ability to tolerate the push and pull, without deforming. On the metal structure is glued strain gauges forming a Wheatstone bridge. It is the mechanical tensile and compressive...
A load cell is a transducer which generates an electrical signal whose size is directly proportional to the force transducer is affected by.
a load cell may take many forms in steel, aluminum, where the choice of material allows the load cell the ability to tolerate the push and pull, without deforming. On the metal structure is glued strain gauges forming a Wheatstone bridge. It is the mechanical tensile and compressive stress as change resistors in the Wheatstone bridge. A special roads amplifier connected to the Wheatstone bridge and provides an output to a display device or computer. A vejecelles quality is the result of extensive experience, choice of materials, material stress relief and extremely precise workmanship.
There are 18 products.
Active filters
Single point celle m/M8 x 2,5 gevind; Fuld belastning=250 Kg
The standard load cell m / M8 x 1.25 thread
S-beam type
Full Load = 5 kg
Maximum load: 7.5kg
Standard cell m / M8 x 1.25 gevind; Full load = 20 Kg
S-type load cell
impedance input: 410 ohm
Iimpedance output: 350 ohms
Exitation: 10 - 15V
4-wire
Thread in top and bottom: M8 x 1 , 25 mM
Full load = 100kg
Overload: max. 150%
Standardcelle m/M12 x 1,75 gevind; Fuld belastning=500 Kg
Standardcelle m/M12 x 1,75 gevind; Fuld belastning=300 Kg
Standardcelle m/M12 x 1,75 gevind; Fuld belastning=1000 Kg
Standardcelle m/M12 x 1,75 gevind; Fuld belastning=100 Kg
Tryck cellrad m / M20 x 1,5 gänga; Full belastning = 1000 kg
Standard Cell m / M8 x 1,25 Anslutningsgänga; Full belastning = 50 kg
Standard Cell m / M8 x 1.25 thread; Full load = 10 Kg
